nord modular G2 - Sw1-8; ValSw2-1; ValSw1-2; WindSw

To Next Page

To Previous Page

11. Module reference: Switch group NORD MODULAR G2 V1.1

Page 166

1-8

1-81-8

1-8

The 1-8Switch has one input, eight out-

puts and eight Channel Select radio but-

tons which can also be labelled. See also

"Common Switch parameters”

2-1

2-12-1

2-1

The 2-1 Value Switch switches between

two inputs at a definable Control signal

input value.

V V

Set the lower limit where the switch should change to the On input channel. Range: 0-64 units in steps

of 1 unit. See also "Common Switch parameters”.

1-2

1-21-2

1-2

The 1-2 Value Switch directs an incom-

ing control/audio signal between two

outputs at a definable Control signal in-

put value.

V V

Set the lower limit where the switch should redirect the input signal to the On output. Range: 0-64 units

in steps of 1 unit. See also "Common Switch parameters”.

The Window Switch “closes” when an

incoming Control signal value is within

the range set with the From and To pa-

rameters. When the switch closes, a high logic gate signal is also output from the yellow logic output.

Set the lower limit where the switch should close. Range: 0.0-64.0 units in steps of 0.5 units. Note: if the

From value is higher than the To value, the switch never closes.

Set the upper limit where the switch should open. Range: 0.0-64.0 units in steps of 0.5 units. Note: if

the From value is higher than the To value, the switch never closes.

The yellow logic output sends out a high logic gate signal when the switch is closed. See also "Common

Switch parameters”.