nord modular G2 - Cut; Copy; Paste; Clear

NORD MODULAR G2 V1.1 9. Working with the Editor: Patch menu
Page 85
C
CC
C
U
UU
UT
TT
T
Cuts out one or several modules, including their common cable connections and parameter settings, and
places in the clipboard memory.
C
CC
C
O
OO
OP
PP
PY
YY
Y
Copies one or several modules, including their common cable connections and parameter settings, and
places in the clipboard memory.
P
PP
P
A
AA
AS
SS
ST
TT
TE
EE
E
Pastes one or several modules, including their common cable connections and parameter settings, that
previously have been cut or copied to the clipboard memory. The Paste command results in a cursor with
a small ‘+’ sign attached to it. Place the cursor where you want in the Patch window and click to paste the
module(s).
C
CC
C
L
LL
LE
EE
EA
AA
AR
RR
R
Deletes one or several selected modules (and their mutual cable connections) from the Patch window.
P
PP
P
A
AA
AS
SS
ST
TT
TE
EE
E
P
P P
P
A
AA
AR
RR
RA
AA
AM
MM
MS
SS
S
This command should be used if you only want to paste a copied module parameter values to another
module of the same type. You can also select several modules in one Variation, select Copy and then Paste
Params in another Variation.
S
SS
S
E
EE
EL
LL
LE
EE
EC
CC
CT
TT
T
A
A A
A
L
LL
LL
LL
L
Selects all modules in the most recently used section of the Patch window for clearing, copying, moving
etc.
P
PP
P
A
AA
AT
TT
TC
CC
CH
HH
H M
MM
ME
EE
EN
NN
NU
UU
U
P
PP
P
A
AA
AT
TT
TC
CC
CH
HH
H
S
S S
S
E
EE
ET
TT
TT
TT
TI
II
IN
NN
NG
GG
GS
SS
S
Opens up the Patch Settings floating
window. The Patch Settings parame-
ters can be different for different Var-
iations. (These functions are also
available for editing on the synth if
you press the P
ATCH
S
ETTINGS
but-
ton. See “Edit Patch Settings” on
page 63).
S
SS
S
U
UU
US
SS
ST
TT
TA
AA
AI
II
IN
NN
N
P
P P
P
E
EE
ED
DD
DA
AA
AL
LL
L
Select if a sustain pedal/foot switch connected to the S
USTAIN
P
EDAL
input on the rear panel of Nord
Modular G2 should act as a Sustain pedal and On/Off switch or only as an On/Off switch.
Note! If you use it only as an on/off switch (the ‘Off’ alternative), you have to assign the switch to
module parameters in a Patch to the Foot Switch Morph group (see “Morph groups” on page 51).