11. Module reference: MIDI group NORD MODULAR G2 V1.1
Page 196
V
VV
V
A
AA
AL
LL
LU
UU
UE
EE
E
Manually select the Value you want the module to send with the knob. By patching a positive unipolar
control signal to the Value control signal input, you can control the Value from an external source. Range:
0-127 units in steps of 1 unit. See also "Common MIDI module parameters”.
• Note that if you want to send only the values on the Value input, set the knob to ‘0’. Otherwise the
value selected with the knob will be added as an offset to the input signal.
• Note that as soon as the Value changes, either by manually turning the knob or by inputting a
changing control signal, the module will output MIDI data even if the logic Send input is not acti-
vated.
A
AA
A
P
PP
PP
PP
PL
LL
LI
II
IC
CC
CA
AA
AT
TT
TI
II
IO
OO
ON
NN
N
E
EE
EX
XX
XA
AA
AM
MM
MP
PP
PL
LL
LE
EE
ES
SS
S
The CtrlSend module can be used in different types of applications. Here are some basic examples:
1. For assigning and sending a MIDI CC# from a
K
NOB
on the synth panel:
Just drag and drop a CtrlSend module to the
Patch window, select MIDI Ctrl number, MIDI Channel and then assign the Value knob to an
A
SSIGNABLE
K
NOB
on the synth panel. Turning the K
NOB
will then send MIDI CC data to the
MIDI O
UT
of the synth. A very simple solution to be able to control external MIDI gear from the
G2 panel. Tip! To make it easier to see in the A
SSIGNABLE
D
ISPLAY
which parameter you control,
you can rename the module from ‘CtrlSend1’ to e.g. ‘FilterCutoff’. Then, the A
SSIGNABLE
D
ISPLAY
will show ‘FilterCutoff’.
2. For sending a series of different MIDI Control-
lers to external MIDI gear:
Connect several CtrlSend modules in series
where each module sends a certain value on a
certain MIDI CC# on selectable MIDI chan-
nels. In this example, the first module sends the
value 64 for MIDI CC#7 on MIDI channel 1.
Right after this, the second module sends the value 127 for MIDI CC#11 on MIDI channel 1.
Finally, the third module sends the value 50 for MIDI CC#21 on MIDI channel 3. This application
is perfect for sending initial MIDI information to external MIDI equipment.
3. For sending continuous MIDI Controller data
to Patches in other Slots and/or to external
MIDI gear:
Patch, for example, the Control signal output of
a CtrlSeq module and let it modulate the filter
cutoff frequency on a MIDI connected Nord
Lead 3. Select the correct MIDI CC# and cor-
rect MIDI channel and make sure the Value
knob is set to ‘0’. As the CtrlSeq runs. it will
continuously send different Control signal values
to the CtrlSend module, which in turn will output the MIDI CC data on the MIDI O
UT
. In these
type of applications you don’t have to use the logic Send input of the CtrlSend module since the
Value changes continuously.
To Next Page
Loading...
Need help?
General