Positioner Preset Settings
6-1
Part 1056418-07
E 2019 Nordson Corporation
Section 6
Positioner Preset Settings
Contents
Introduction 6-1.............................................
Positioner Preset Settings 6-2.................................
Copying Preset Settings 6-3................................
Saving Preset Settings 6-3.................................
Reset to Defaults 6-3......................................
Using Preset Settings 6-4....................................
Fixed Positioning 6-4......................................
Variable Positioning − Contouring 6-5........................
Variable Positioning − Lancing and Contouring 6-6............
Variable Positioning − Lancing into Deep Recesses 6-7........
Introduction
Positioner presets are recipes that contain the move settings for a specific
part. Up to 255 unique presets can be created on each user data card.
Positioner Preset settings are part-specific. If no preset settings have been
made for a part, the system uses the default positioner settings from the
Configuration screen.
NOTE: If you set any preset settings to less than the configured minimum
settings, then the minimum settings override the preset settings.
Refer to Section 5, Positioner/Reciprocator Configuration for more
information on default and minimum settings.
In/Out Positioner Settings:
S lead and lag move points
S gun to part distance (variable)
S gun position (fixed)
To Next Page
Loading...