Nordson iControl Series - User Account Management; Creating New User Accounts; Editing and Deleting User Accounts

Security System
2-4
Part 1056418-07
E 2019 Nordson Corporation
Creating a User
See Figure 2-3. Use the Create/Edit User area.
1. Enter a user name in the User Name field (13).
2. Select a security level from the Security Level drop-down list (12).
Refer to the Security Levels and Access Rights table on page 2-5.
3. Enter a Password, once in each password field (11, 10). Passwords
are case-sensitive.
4. Touch the OK button (5). To delete the user touch the Delete button (6).
NOTE: All fields must be filled out correctly, or one of the following
graphical error messages appears:
User Name
Error
Security Level
Error
Password
Error
Figure 2-4 User Error Messages
Editing a User
1. See Figure 2-3, Select Existing User area. Select a User name (2). The
user name, security level, and password appears in the Create/Edit
fields.
2. Edit the fields as desired, then touch the OK button (5).
3. To delete the user touch the Delete button (6).
Setting the Automatic Log Out Timer
See Figure 2-3. Automatic log out only applies to supervisor-level (level 4)
users. To set up automatic logout:
1. Enable automatic log out (8).
2. Set the timer (7). Time is in seconds (0−999).
A clock icon appears next to the user name on the Main screen when
automatic log out is enabled. The timer starts when no activity in the user
interface is detected, and the user is logged out when the timer expires.
NOTE: Automatic logout is always enabled for Nordson CSRs and
Engineers and cannot be changed or disabled for them.