Security System
2-2
Part 1056418-07
E 2019 Nordson Corporation
Introduction (contd)
On a new system, touching the Configure button displays the security
configuration screen but all functionality is disabled. The security system
must be set up by a Nordson Customer Service Representative or
engineer. When the CSR logs in the security configuration functionality is
enabled. Once the security system is enabled and configured, the Security
Configuration screen is only available to a user with level 4 access rights.
NOTE: Even if the security system is disabled, Nordson representatives still
have to log in to access the Nordson−only system configuration settings.
Access to screens and functions depends on the security level assigned to
the user. Refer to the security access table on page 2-5 for a list of access
rights by function and user level.
Logging In
Only one user can be logged in at a time. When a new user logs in the
previous user is automatically logged out.
1. See Figure 2-2. Touch the Log In button on the Log In/Out screen to
open the Log In screen.
User Name
Password
OK
014
Figure 2-2 Logging In
2. Touch the User Name field and select your user name.
3. Touch the Password field. The keyboard opens. Enter your password
on the keyboard screen. Passwords are case-sensitive.
4. Close the keyboard.
5. Touch the OK button to log in.
To Next Page
Loading...