Spray Gun Preset Settings
5-2
Part 1056418-07
E 2019 Nordson Corporation
In Manual Part ID mode, you can select any preset for any part. This is
commonly called batch mode.
Spray Gun Preset Settings:
S air or powder flow
S voltage output, current output limits, Select Charge mode
S lead and lag trigger points
S zone assignment
Spray Gun Preset Screens
Spray gun presets can be set with either the Gun Control screens or the
Preset Table screen.
The Gun Control screens allow you to set presets for one gun, one preset
at a time. You can use these screens online or offline. The Gun Control
screens have Copy functions that will copy preset settings to other presets
for the same gun and to presets for other guns.
The Preset Table screen allows you to view and set preset settings for all
guns in the system, one preset at a time, in a table format. Use this screen
offline only to quickly setup and modify your presets.
Preset
Table Screen
Gun Buttons − Gun Control Screens
Figure 5-1 Spray Gun Preset Screens
Spray Gun Control Screen
See Figure 5-2. Use the Gun Control screens to set the following preset
settings:
S preset number (2) and name (1)
S flow-rate and atomizing air flow (3) for standard guns) or powder flow
and pattern air for Prodigy guns
S electrostatics (4)
S lead (5) and lag (7) trigger points
S zone assignment (6)
To copy your settings, use Copy All (8) or Copy Selected (10). Refer to
the explanations starting on page 5-15.
The Keypad button (9) opens a keypad that you can use to enter settings.
To Next Page
Loading...