Monitoring Operation
9-6
Part 1056418-07
E 2019 Nordson Corporation
Hours ON
Total Hours
Maintenance
Hours
Pump Hours
Gun Hours
Figure 9-4 Gun Hourmeter
Part ID
The part ID number and name of the part entering the booth is displayed at
the bottom left of the main screen.
NOTE: The part information displayed is the part in front of the zone
photoeyes, not the part being coated.
The Part ID Mode button displays the current Part ID mode: Auto or
Manual. Refer to Setting Part ID Mode on page 8-6 for information on the
part ID modes.
Part ID Mode Part ID Number Part Name
Figure 9-5 Part ID Mode Indicator, Part ID Number, and Part Name
Input Status
Touch the Input Status button on the Main screen to open the Input Status
screen. Use this screen to check the operation of the zone photoeyes or
scanners, part ID inputs, and your gun mover/reciprocator scanners.
The Zone Indicators light when a part passes by the zone photoeyes or
scanner. They indicate which zones the part occupies. The Part Height is
displayed when an analog scanner is used to detect part height.
The Part ID Indicators light when they receive a part ID signal. The Part
ID Number is displayed below the indicators.
To Next Page
Loading...