Monitoring Operation
9-7
Part 1056418-07
E 2019 Nordson Corporation
Input Status (contd)
The Part Width left and right of the conveyor centerline is displayed when
one or two analog scanners are used to detect part width.
Part ID
Part Width
Left and Right
of Centerline
Part
Height
Zone
Indicators
Part ID
Indicators
Figure 9-6 Input Status Screen
Color Change Monitoring
If you have a SpeedKing or other booth, the iControl system controls color
change operations.
NOTE: If you have a USA ColorMax booth, color change operations are
run by a separate PLC. The iControl system has no control over the color
change. The in/out positioners are configured for USA ColorMax.
The Park Indicator turns yellow during a color change and appears on the
Main screen. Touching the Park Button will abort the color change
operation during all cycles, except for SpeedKing Booths.
For SpeedKing booths, the Park Button aborts the color change operation
only during the gun purge and blowoff cycle. During the Arch Cleaning
cycle the Park Button is deactivated.
NOTE: If an external problem aborts a SpeedKing color change operation,
touch the Alarm Reset button, then the Park Button to abort the iControl
color change cycle.
The color change states are as follows:
1. Request Clean Cycle from positioner 1: Display cleaning icon.
2. Clean Cycle pending: Indicator 1 lights green. Waiting for parts to exit
the booth.
3. Clean Cycle ready: Indicator 2 lights green. Purge permission sent to all
positioners.
To Next Page
Loading...