Introduction
1-3
Part 1056418-07
E 2019 Nordson Corporation
Touch Screen: Touch the buttons, controls, and fields displayed on the
iControl screens to make settings, control system devices, and open and
close screens. The touch screen must be calibrated in order to respond
correctly to your touch. To re-calibrate the touch screen, refer to Section
3, Configuration.
Rotary Dial (iControl 1 only): Use the dial to increase and decrease
numerical values in data fields or to toggle through a range of possible
settings. Select a data field and rotate the dial clockwise to increase;
counterclockwise to decrease.
NOTE: IControl 2 master consoles and pedestals have an enhanced
on-screen keypad with arrow keys that perform the same function as the
rotary dial.
Interlock Keyswitch: The keyswitch has three positions:
S Ready: Run system (conveyor on signal is required)
S Lockout: Use to shut off guns, in/out positioners, and reciprocators
S Conveyor Bypass: Use to trigger guns without a conveyor ON signal
NOTE: Lockout can be overridden for in/out positioners and reciprocators
through their configuration screens.
Common Interface Objects and Buttons
Configure: Touch this button to
open most configuration screens.
Data Fields: Touch a field to select
it, then use the rotary dial or up and
down arrows to edit the field value.
Close: Touch this button to close
open screens.
Keypad: Select a data field, then
touch this button to open the keypad
and enter values.
Radio Buttons: Touch a button to
select an option. Only one button in
a group can be selected.
OK: Touch to acknowledge a
message, proceed with an action, or
enable a feature.
Drop-down Fields: Touch the field
to open a drop-down list and select
a value.
Cancel: Touch to cancel changes
or an action, or disable a feature.
To Next Page
Loading...