Nordson iControl Series - Spray Gun Preset Settings; Introduction to Spray Gun Presets; Safety Warning for Preset Tasks

Spray Gun Preset Settings
5-1
Part 1056418-07
E 2019 Nordson Corporation
Section 5
Spray Gun Preset Settings
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Contents
Introduction 5-1.............................................
Spray Gun Preset Screens 5-2................................
Spray Gun Control Screen 5-2..............................
Spray Gun Preset Table Screen 5-3.........................
Preset Number and Name 5-4................................
Air Flow Settings for Venturi Pumps 5-5........................
Pressure to Flow Conversion Tables 5-6.....................
Smart Flow Settings for Venturi Pumps 5-7.....................
Smart Flow Tables 5-7.....................................
Smart Flow Settings − Metric Units 5-9....................
Smart Flow Settings − English Units 5-10...................
Prodigy/Encore HD Air Flow Settings 5-11.......................
Electrostatic Settings 5-12.....................................
Setting kV 5-13............................................
Setting AFC 5-13...........................................
Select Charge Mode 5-13...................................
Lead and Lag Settings 5-15....................................
Perfect Pickoff Example 5-16................................
Extended Spray Example 5-16...............................
Restricted Spray Example 5-17..............................
Extended-Restricted Spray Example 5-17.....................
Zone Assignment 5-18........................................
Using Zones to Prevent Triggering 5-18.......................
Copy All: Gun Control Screen 5-19.............................
Copy All: Preset Table Screen 5-19.............................
Copy Selected: Gun Control Screens 5-20.......................
Introduction
Spray gun presets are recipes that contain the spray settings and trigger
settings for a specific part. Up to 255 unique presets can be created on
each user data card.
When the system is operating in Automatic Part ID mode, a part with an ID
number of 2 is sprayed with preset 2 settings. Although all guns spray the
part using the same preset, the settings for the preset can be different for
each gun.