Nordson iControl Series - Reciprocator Preset Settings; Introduction to Reciprocator Presets; Reciprocator Settings Overview

Reciprocator Preset Settings
7-1
Part 1056418-07
E 2019 Nordson Corporation
Section 7
Reciprocator Preset Settings
Contents
Introduction 7-1.............................................
Reciprocator Preset Screens 7-2..............................
Copying Preset Settings 7-2................................
Saving Preset Settings 7-2.................................
Reset to Defaults 7-2......................................
Fixed Mode Settings 7-3.....................................
Variable Mode Settings 7-5...................................
Reciprocator Preset Percent-Adjust Settings 7-6.................
Introduction
Reciprocator presets are recipes that contain reciprocator move settings
and trigger settings for a specific part. Up to 255 unique presets can be
created on each user data card.
Reciprocator Preset settings are part-specific. The system will use the
default reciprocator settings from the Configuration screen for all parts
without preset settings.
Refer to Section 4, Positioner/Reciprocator Configuration for more
information on default and minimum settings.
Reciprocator Settings:
S spray gun trigger on/off up/down points (fixed mode)
S reciprocator turn-around points (fixed and variable modes)
S reciprocator speed (fixed and variable)
S reciprocator overtravel distances (variable)
S flow-rate and atomizing air percent adjust