Nordson iControl Series - Lancing Default Moves Example

Ethernet and Gun Mover Configuration
4-17
Part 1056418-07
E 2019 Nordson Corporation
Lancing Default Moves Example (contd)
2. Part in front of guns:The positioner follows the contours of the part as
the part moves by the spray guns, maintaining the 10-inch gun to part
distance.
Conveyor Centerline
Retract Position
(Wait Position)
Spray Position
Figure 4-11 Part in Front of Guns: Gun-to-Part Distance Maintained (Top View)
3. Part at Lag: When the trailing edge of the part is 2 inches from the
guns, the positioner moves the guns back to the Retract position.
Conveyor Centerline
Lag: −2 in.
Retract Position
(Wait Position)
Figure 4-12 Part at Lead: Move Forward to Default Gun to Part Distance (Top View)