Nordson iControl Series - Reciprocator Configuration; Reciprocator Configuration Screen; Reciprocator Configuration Settings List

Ethernet and Gun Mover Configuration
4-18
Part 1056418-07
E 2019 Nordson Corporation
Reciprocator Configuration
Touch the Reciprocator Configure button on the System Configuration
screen to open the Reciprocator Configuration screen.
Use this screen to configure your reciprocators and make default move
settings that apply to all parts. To make part-specific reciprocator move
settings, refer to Section 6, Reciprocator Presets.
1
2
3
4
6
5
7
28
8
9
10 11
12
13
14
15
16
17
18
19
20 2122
23
25
26
27
29
24
30
Figure 4-13 Reciprocator Configuration Screen
1. Mode Indicator
2. Reciprocator Selector
3. Mode Buttons: Off, Manual, Auto
4. Lock in Off Mode
5. Select Side of Booth
6. Open Keypad
7. Jog Up/Down
8. Bottom Soft Limit
9. Top Soft Limit
10. Current Position
11. Fixed/Variable Move Settings
12. Fixed, Conveyor Sync Mode
13. Variable, Conveyor Sync Mode
14. Fixed, No Sync Mode
15. Variable, No Sync Mode
16. Oscillator Mode
17. Lockout Override
18. Master/Slave Setting
19. Maximum Speed
20. Turn-Around Offset
21. Accel/Decel Time
22. Park/Clean Position
23. Encoder Resolution
24. Hysteresis Setting
25. Guns on Reciprocator
26. Number of Laps
27. Width of Pattern
28. Home Button
29. Air Flow Percent Adjust
30. Speed (No Sync Mode Only)
Note: Settings 19, 20, and 21 can only be changed by a Nordson representative.