Standard System Configuration
3-36
Part 1056418-07
E 2019 Nordson Corporation
Touch Screen Calibration (contd)
NOTE: Previous versions of the calibration procedure only required a
single touch to each target. The new version requires that the user touch
and hold the target until it moves. If the targets are not responsive, there
may be a problem with the touch screen hardware.
If you do not follow the calibration instructions exactly, you will not be able to
touch the center Completion or Accept button and exit the calibration
procedure. If this happens, stop and wait until the procedure times out and
restarts. You should then be able to repeat the procedure and complete it
correctly.
The complete procedure times out in 90 seconds. If you do not touch the
Completion or Accept button within 10 seconds of pressing the third target
the procedure will restart.
When you have completed the calibration procedure, touch the iControl
button to start the iControl software.
To Next Page
Loading...