Table of Contents
iv
Part 1056418-07
E 2019 Nordson Corporation
Positioner Preset Settings 6-1...............................
Contents 6-1...............................................
Introduction 6-1.............................................
Positioner Preset Settings 6-2................................
Copying Preset Settings 6-3...............................
Saving Preset Settings 6-3................................
Reset to Defaults 6-3.....................................
Using Preset Settings 6-4....................................
Fixed Positioning 6-4.....................................
Variable Positioning − Contouring 6-5.......................
Variable Positioning − Lancing and Contouring 6-6............
Variable Positioning − Lancing into Deep Recesses 6-7........
Reciprocator Preset Settings 7-1............................
Contents 7-1...............................................
Introduction 7-1.............................................
Reciprocator Preset Screens 7-2..............................
Copying Preset Settings 7-2...............................
Saving Preset Settings 7-2................................
Reset to Defaults 7-2.....................................
Fixed Mode Settings 7-3.....................................
Variable Mode Settings 7-5...................................
Reciprocator Preset Percent-Adjust Settings 7-6................
Operation 8-1..............................................
Contents 8-1...............................................
Screen Icons 8-2...........................................
System Startup 8-3.........................................
Using the Console Keyswitch 8-3.............................
Lockout 8-3..............................................
Main Screen Operating Functions 8-4.........................
Global Mode Controls 8-5....................................
Spray Gun Global Control − Manual Spray Control 8-5........
Part ID Control 8-6..........................................
Part ID Modes 8-6........................................
Batch Coating 8-6........................................
Purge Controls 8-7..........................................
Versa-Spray Manual Purge Controls 8-7.....................
Prodigy/Encore HD Purge Controls 8-7......................
Percent Adjust Functions 8-9.................................
Percent Adjust Additive Effects 8-9.........................
Global Percent Adjust 8-9.................................
Conveyor Speed Percent Adjust 8-10........................
Spray Gun Controls 8-11.....................................
Copying Changes to Presets 8-11...........................
Trigger Mode and Manual Triggering 8-11.....................
Turning Individual Guns On and Off 8-12.....................
Positioner Controls 8-13......................................
Positioner Operating Modes 8-13
............................
Control Screen Indicators and Functions 8-13.................
Positioner Homing and Startup Sequence 8-14................
Reciprocator Controls 8-15....................................
Reciprocator Operating Modes 8-15..........................
Control Screen Indicators and Functions 8-15.................
Default and Preset Setting Adjustments 8-16..................
Reciprocator Lap Calculator 8-17............................
To Next Page
Loading...