Nordson PURBlue 4 - Optional Equipment; Flow;Pressure Control and Pressure Indication; Expansion and Control Kits; Cooling Fan and Light Tower

Parts
7-31
Part 1120277_01
E 2012 Nordson Corporation
Optional Equipment
Flow/Pressure Control and Pressure Indication
Part Description Note
1034042 KIT,RUN UP CONTROL VALVE,1100 PSI
1093136 KIT, ACCESSORY, F OPTION, PB4 (flow control bypass) A
1030537 KIT, GAUGE, 1500 PSI
NOTE A: This option is already present on some melter configurations. It may also be field-installed on a melter that
does not have this option. Refer to Melter Part Numbers earlier in this to determine the configuration of your
melter.
Expansion and Control Kits
Part Description Note
1036607 KIT, I/O EXPANSION CARD (DIGITAL)
1063740 KIT, ANALOG I/O BOARD
1053288 KIT, DEVICENET CARD
1053289 KIT, ETHERNET CARD
1053300 KIT, PROFIBUS CARD
1030542 KIT, FOOTSWITCH
1047093 KIT, REMOTE TRIGGER
1029938 CABLE ASSY, RIBBON, SERIAL PORT, 9 POS, DURA
Cooling Fan and Light Tower
Part Description Note
1095995 KIT,ACCESSORY,FAN,PB4
1097938 KIT,LIGHTTOWER,MAG.BASE,PB4
Line-Speed Signal Generator
To use the gear-to-line capability of the melter, you must install a device that
measures the speed of the production line. The default type of line-speed
signal input is 0-10 VDC, although other inputs can be accepted. Nordson
Corporation offers the following 0-10 VDC generator.
Part Description Note
119560 GENERATOR, 0-10 VDC, WITH BRACKET AND CABLE