Control switch
Pump speed display and arrow keys
Pump mode key
Installation
3-44
Part 1120277_01
E 2012 Nordson Corporation
Setting Up the Motor Control
The motor control parameters are factory-set and may not need to be
changed. Follow this procedure if your application requires a change to a
motor control parameter.
To change a motor control parameter
1. Switch the melter off.
2. Press and hold both Pump speed arrow keys and then switch the melter
back on. When the motor control display indicates SEt, release the keys.
3. Use the Pump speed arrow keys to select a value for the parameter
shown on the pump speed display. Refer to Table 3-10 for a parameter
list.
4. Press the Pump mode keytosavethevalueandmovetothenext
parameter.
5. Repeat steps 3-4 for each parameter you want to change.
6. To exit the setup mode, press the Pump mode key one additional time
after the last parameter has been displayed.
To Next Page
Loading...
