Nordson PURBlue 4 - Connecting a Compressed Air Supply

Installation
3-18
Part 1120277_01
E 2012 Nordson Corporation
Connecting a Compressed Air Supply
To connect an air supply
SeeFigure3-7.
1. Connect a regulated plant air supply to the air supply inlet (2) a t 6.2 bar
(90 PSI) using M6 flexible tubing.
2. Open the plant air supply to the melter.
3. Turn the air regulator (1) to set the melter's operating air pressure
(pressure supplied to the piston) to 2 bar (30 PSI).
1
2(6mm)
Figure 3-7 Location of the air supply input port
1. Piston air regulator and gauge 2. Air supply inlet