Reservoir key
Left display and scroll key
Enter key
Reservoir key
Ready LED
Installation
3-29
Part 1120277_01
E 2012 Nordson Corporation
To assign a global setpoint temperature
1. Press and hold the Reservoir key for three seconds.
The left display flashes 1.
2. Scroll the left display to 0.
The right display indicates all dashes (----) and the LEDs on the reservoir,
hose, and gun keys turn green.
3. Press the Enter key.
The right display flashes.
4. Use the numeric keypad to enter the setpoint temperature recommended
by the manufacturer of the hot melt.
Refer to the technical data sheet provided by the manufacturer of the hot
melt to determine the optimal setpoint temperature.
5. Press the Reservoir key.
Each component begins to heat or cool to the new global setpoint
temperature and the melter returns to the automatic scan mode.
When all of the components reach the global setpoint temperature, the
ready LED turns on (green).
To Next Page
Loading...
