Setup key
Clear/reset key
Heaters key
Operation
4-19
Part 1120277_01
E 2012 Nordson Corporation
To put the melter back into operation
1. Diagnose and correct the fault condition. Refer to Section 6,
Troubleshooting, for information about diagnosing and correcting fault
conditions.
NOTE: When a fatal F4 fault exists, the control switch will not function.
Remove power to the melter at the local disconnect switch.
2. Return the melter to the automatic scan mode by pressing the Setup key
twice.
3. Press the Clear/reset key.
4. Press the Heaters key to turn on the heaters.
To Next Page
Loading...
