6 Handling USB
24 © Nortec Electronics 2018
6.3 USB
The device has got an inbuilt USB interface. This can be used to write the recorded data on an
USB flash drive.
The data of the last battery measurements can be copied on the stick using menu choice „Write on
USB flash drive “.
An easier method is to put in the USB flash drive before the end of the charging routine in order to
transfer the data to the stick automatically after the end of the routine. You can keep the USB flash
drive permanantely in the USB-interface. All data will be recorded automatically.
NOTE!
The device only records data of programs which were started using the key (printer started).
Inside the UL60 the data for the last measurements will be deleted and the new data will be stored.
The USB flash drive can be taken out as soon as the program is finished and the display shows:
„Data successfully written on USB flash drive “.
On the USB flash drive 2 files are kept:
The UL 60 automatically generates the filenames continuously from the date and time.
First file:
One text file (.rtf). This file can be opened in Word or OpenOffice. This file contains the same text
as printed on the inbuilt printer. Additionally, the charging and discharging curves are displayed in
case the program chosen contains both routines.
To Next Page
Loading...
