Page 136 of 206 Troubleshooting
553-3001-304 Standard 3.00 September 2004
Wireless handset status messages
Wireless handset status messages provide information about the WLAN
Handsets 2210/2211’s communication with the AP and Call Server. Table 19
summarizes the status messages, in alphabetical order.
Table 19
Wireless handset status messages (Part 1 of 11)
Message Description Action
3 chirps Wireless handset is not able to
communicate with the best AP,
probably because that AP has
no bandwidth available
None. This is only a warning.
The call will handoff to the best
AP once it becomes available.
Assert Server internal error. Note the displayed screen data
and inform the system
administrator. Power-cycle the
wireless handset.
Bad Config Some needed configuration
parameter has not been set.
Check all required wireless
handset configuration
parameters for valid settings.
Bad ESSID The wireless handset is
configured for “static ESSID”
(as opposed to “Learn once” or
“Learn always” and no ESSID
has been entered.
Enter an ESSID in the
configuration settings or change
to one of the “Learn” modes.
To Next Page
Loading...
