Nortel 2245 - TPS CLI Commands

Troubleshooting Page 149 of 206
WLAN IP Telephony Installation and Configuration
LD 117 STIP command
The STIP command can be used for wireless handsets; however, the wireless
handset alias IP address is displayed as the TERMIP in the command output,
instead of physical IP address. In the following example, the
“192.168.10.200” is an alias IP address assigned by the WLAN IP Telephony
Manager 2245.
TN HWID STATUS HOSTIP TERMIP PORT
______ _______________________________ ______ __________ ____________ _______
0x600a 00000000000003000907a017e476607 REG 47.11.214.165 192.168.10.200 0x1450
CAPS
_________
0x00000000
--------------------------------
codec bdwth(k) codecCaps desc
--------------------------------
4 190 0x00000000 1
3 190 0x00000000 1
17 47 0x00000001 1
value = 537232412 = 0x2005841C
Note: For information on more CLI commands, refer to “Zones” on
page 52.
TPS CLI commands
dsetShow command
In the dsetShow command output, the WLAN Handsets 2210/2211 have a
specific Hardware ID. The alias IP address is output, not the physical wireless
handset IP address.
In the following example, the IP Phone 2004 has an IP address of
192.168.10.100 and the WLAN Handset 2211 has an alias IP address of
192.168.10.200.The Hardware ID is broken down as follows:
• first two digits – Manufacturer Location. Manufacturer Location is 18 for
the IP Phone 2004 and 30 for the WLAN Handset 2211.