WLAN Handsets 2210/2211 configuration Page 85 of 206
WLAN IP Telephony Installation and Configuration
Configuration tasks
To enable the WLAN Handsets 2210/2211 to operate on the WLAN system,
perform the following tasks:
1 Configure WLAN Handset 2210/2211. See “Configuring the WLAN
Handset 2210/2211” on page 85.
2 Program the features on the wireless handset. See “Feature
programming” on page 101.
3 Test the wireless handset. See “Testing the wireless handsets” on
page 106.
Note: The WLAN Handsets 2210/2211 require special configuration to
enable them to communicate with the optional WLAN Application
Gateway 2246. Ensure that these settings are correct. Refer to “Opening
and using the Admin Menu” on page 85.
Configuring the WLAN Handset 2210/2211
Opening and using the Admin Menu
The Admin Menu contains configuration options that are stored locally on
each wireless handset. Every wireless handset is independent. If the default
settings are not desired, the Admin options must be configured in each
separate wireless handset that requires different settings.
Follow the steps in Procedure 8 on page 85 to open and use the Admin Menu
on the wireless handset.
Procedure 8
Opening and using the Admin menu on the wireless handset
1 With the wireless handset powered OFF, simultaneously press and hold
the Power On / Start Call
and Power Off / End Call keys.
2 Release the Power On / Start Call
key, then release the
Power Off / End Call key. The first option on the Admin Menu displays.
Note: If an Admin Password has been configured, the display requires its
entry before opening the Admin Menu. If no password is configured, the
display proceeds directly into the Admin Menu.
To Next Page
Loading...
