Page 110 of 206 WLAN Handsets 2210/2211 configuration
553-3001-304 Standard 3.00 September 2004
Confirm supported data rates
Press
FCN to toggle to the Detl function which displays details of the
specific AP. Use this information to confirm signal strength and supported
data rates.
• # is the number (1 – 4) of the AP
• Full MAC is the MAC address of the AP
• dB is the signal strength of the AP
• Ch is the channel of the AP
• 1b2b5b11b is an example of the data rate that may be displayed
Walk around the site to determine supported data rates, one AP at a time. In
any location, use the Right Arrow key to display the second best AP. Use the
Right Arrow key again to display the third best, and then the fourth best. The
Left Arrow key returns the display back to the first best AP.
Each data rate (1, 2, 5.5, or 11Mb/s) supported by the AP is shown. The rates
that are in the Basic Rate set (sometimes referred to as “required” rates) are
indicated by a ‘b’ following the rate number. The Supported and Basic data
rate(s) should be the same on all APs as is appropriate for the site.
Push To Talk
The Push To Talk (PTT) feature allows the WLAN Handset 2211 to operate
in a PTT group-broadcast mode like a two-way radio, in addition to the
standard telephone operation. The WLAN Handset 2211 supports eight
multicast channels with the current channel saved in memory on the wireless
handset.
# : FULL MAC
dB Ch 1b2b5b11b
Detll
To Next Page
Loading...
