WLAN Handsets 2210/2211 configuration Page 107 of 206
WLAN IP Telephony Installation and Configuration
5 Press the Power On / Start Call key. Any line indicators turn off and the
extension number display returns.
End of Procedure
Site certification
Ensure the wireless handsets are adequately supported by the site.
Conduct a Site Survey. Note any areas where coverage is conflicting or
inadequate. Note any system difficulties and work with the system
administrator to determine the cause and possible remedy. Refer to
“Conducting an effective site survey” on page 35 for information on
conducting a site survey. Refer to “Troubleshooting the WLAN Handset
2210/2211” on page 133 for clues to possible sources of difficulties.
The testing must be performed in typical operating conditions, especially if
heavy loads occur. Generally, organize the test according to area and volume,
placing numerous calls to others who can listen while coverage tests are
performed. Note any areas with excessive static or clarity problems and report
it.
Testing signal strength with the WLAN Handset 2210/2211
This test can only be performed if the Nortel Networks WLAN system has
been installed and configured.
Follow the steps in Procedure 13 to test AP signal strength using the wireless
handsets.
Procedure 13
Testing signal strength using the wireless handset
1 Test signal strength in the covered area by putting a WLAN Handset
2210/2211 in Site Survey Mode.
Refer to “Site Survey Mode” on page 93.
2 Walk the entire coverage area while viewing the display.
To Next Page
Loading...
