Page 96 of 206 WLAN Handsets 2210/2211 configuration
553-3001-304 Standard 3.00 September 2004
Terminal type
Select i2004. The Terminal type configures the wireless handset for the type
of PBX in use. The CS 1000 and Meridian 1 systems require the i2004 setting;
the BCM requires the 3rd-party setting.
OAI On/Off
Nortel Network’s Open Application Interface (OAI) enables the wireless
handset to connect with the optional WLAN Application Gateway 2246. This
device allows third-party computer applications to display alphanumeric
messages on the wireless handset display and take input from the wireless
handset keypad. Refer to Appendix A: “WLAN Application Gateway 2246”
on page 155 for more information.
If a WLAN Application Gateway 2246 is installed in the system, OAI may be
optionally enabled in each wireless handset. Select whether the wireless
handset should attempt to connect to the WLAN Application Gateway 2246
by choosing either the Enable or Disable options in this menu.
If OAI is enabled, and a WLAN Application Gateway 2246 IP address is
available to the wireless handset (either through DHCP or Static IP
configuration), then the wireless handset communicates with the WLAN
Application Gateway 2246 at power-on, and then periodically during the time
the wireless handset is powered on.
If a WLAN Application Gateway 2246 is not installed at the site, disable the
OAI feature to preserve network bandwidth and battery life.
Admin PW
The optional Admin PW (Password) controls access to the administration
functions in the Admin Menu of the wireless handset. Configure the password
in each wireless handset for which controlled access is desired. Wireless
handsets are shipped without any Admin password.
To Next Page
Loading...
