WLAN Handsets 2210/2211 configuration Page 93 of 206
WLAN IP Telephony Installation and Configuration
• Learn Always – allows the wireless handset to automatically learn the
ESSID at each power-on or loss of contact with the wireless LAN (out of
range). This may be useful if the wireless handset will be used at more
than one site.
• Static Entry – if the APs do not accept broadcast ESSID, or if there are
overlapping wireless systems in use at the site, enter the correct ESSID
manually.
License Management
License Management enables selection of the VoIP protocol that the site is
licensed to download and run. The UNIStim Protocol to use for the WLAN
Handsets 2210/2211 is
010. Any other protocol causes the wireless handset
to malfunction.
After selecting the correct protocol for the site, Nortel Networks recommends
upgrading the software for the wireless handsets. See “Updating software on
a wireless handset” on page 123.
Restore Defaults
The Restore Defaults option resets all user and administrative parameters to
their factory defaults. During configuration, press the right arrow to skip this
mode.
Site Survey Mode
Site Survey Mode is used to check the signal strength from APs. When Site
Survey Mode is selected, the wireless handset remains in this mode until it is
powered off. During configuration, press the right arrow to skip this mode.
See “Site survey” on page 32 for more information on using this mode.
Regulatory Domain
The Regulatory Domain defaults to North America on the wireless handset
display. FCC requirements dictate that the menu for changing the domain be
available by password, which in this case is the
LINE button. To change the
domain, press
LINE and then enter the digits that represent the site’s
domain. Both digits must be entered.
To Next Page
Loading...
