Appendix A: WLAN Application Gateway 2246 Page 161 of 206
WLAN IP Telephony Installation and Configuration
3 Plug the power adapter into an outlet or outlet strip.
4 Apply power to the WLAN Application Gateway 2246.
• Ensure the The ERROR LED is off.
• Ensure LED 1 is blinking.
End of Procedure
Configuring the WLAN Application Gateway 2246 IP address
It is necessary to connect to the WLAN Application Gateway 2246 through a
serial connection to configure the IP address and the network parameters.
Once this is done, administration and further configuration can be performed
through a Telnet connection using the Administration Console.
Follow the steps in Procedure 18 to make a serial connection to the WLAN
Application Gateway 2246.
To Next Page
Loading...
