9RLFH $ODUP 6
VWHPV
Audio Amplifiers
66 AFC-600 Operations PN 51033:A 3/8/99
$$$XGLR$P
OLILHUV
1RWH
)RU LQVWUXFWLRQV RQ VHWWLQ
WKH $XGLR *DLQ 5RWDU
6ZLWFK
UHIHU WR +RZ WR $G
XVW WKH
$XGLR *DLQ /HYHO IRU DQ $XGLR
$P
OLILHU RQ
D
H
Figure 70 shows the layout of the AA-30 circuit board and identifies AA-30
components:
)LJXUH $$ &LUFXLW %RDUG
Table 31 lists the conditions that cause each AA-30 LED to light:
7DEOH $$ /('V
Notes:
1. The amplifier does not indicate a trouble condition until 40 seconds after these
faults occur.
2. To calibrate audio amplifiers, install a 470-ohm resistor at the end of the low-level
audio circuit. If the low-level audio circuit is configured as four-wire looped
circuit, install a 470-ohm resistor at the point furthest from the AMG-1 or ATG-2.
LED Lights when
NORMAL
LEVEL
The audio amplifier is adjusted properly and operating correctly
during normal (non-alarm) conditions.
INCORRECT
LEVEL
The audio amplifier is out of adjustment during normal (non-alarm)
conditions.
SPEAKER
TROUBLE
An open circuit condition occurs in the four-wire, high-level output.
AMPLIFIER
TROUBLE
A loss of the low-level audio input signal, or an amplifier failure.
BATTERY
TROUBLE
The battery voltage is below a sufficient level.
BROWNOUT
The AC power source is below a sufficient level. During a complete
loss of AC power, no LEDs will light on the AA-30.
$XGLR *DLQ 5RWDU
6ZLWFK
1RUPDO /HYHO /('
UHHQ
,QFRUUHFW /HYHO /('
HOORZ
6
HDNHU 7URXEOH /('
HOORZ
$P
OLILHU 7URXEOH /('
HOORZ
%DWWHU
7URXEOH /('
HOORZ
%URZQRXW /('
HOORZ
5HVLVWRUV 5 DQG 5
&XW IRU R
WLRQDO
VX
HUYLVLRQ
Technical Manuals Online! - http://www.tech-man.com