Notifier AFC-600 User Manual

ATG-2 Audio Tone Generator
 9RLFH $ODUP 6
\
VWHPV
AFC-600 Operations PN 51033:A 3/8/99 61
+RZWR2
S
HUDWHWKH$7*
Table 25 contains instructions for operating the ATG-2.
7DEOH  2
S
HUDWLQ
J
WKH $7*
+RZWR6HOHFW7RQHVIRUWKH$7*
The ATG-2 DIP switch—S1 located on the ATG-2 board shown in Figure 67—provides
switches for selecting output tones and setting operations. When finished setting
switches, check the ATG-2 for proper operation. Figure 67 shows the ATG-2 board
layout and identifies DIP switch S1 and resistor R134:
)LJXUH  $7* &LUFXLW %RDUG /D\RXW
Continued on the next page...
To Do this
Select the paging channel Press the
EVAC CHANNEL
switch to select the Evacuation
(primary) channel; or press the
ALERT CHANNEL
switch to
select the Alert (secondary) channel.
Verify the active channel
Check the
EVAC CHANNEL
and
ALERT CHANNEL
LEDs.
Page Press the microphone switch and speak into the
microphone (loudly enough to light the green
ON LINE
LED).
Enable single-channel
operation
Cut resistor R134 on the ATG-2 board (see
Figure 67
).
3$*( 6(/(&7
VZLWFK ² 3XVK XQWLO WKH
/(' RQ WKH VHOHFWHG FKDQQHO OL
J
KWV
',3 6ZLWFK 6 IRU
FRQIL
J
XULQ
J
WKH
$7*
5HVLVWRU 5 ² &XW 5 IRU
VLQ
J
OHFKDQQHO R
S
HUDWLRQ
Technical Manuals Online! - http://www.tech-man.com

Notifier AFC-600 Specifications

General

Brand	Notifier
Model	AFC-600
Category	Fire Alarms
Language	English