+RZ WR 2
HUDWH WKH &RQWURO 3DQHO
How to Operate the Control Panel with an Active Supervisory Signal
24 AFC-600 Operations PN 51033:A 3/8/99
+RZWR2SHUDWHWKH&RQWURO3DQHOZLWKDQ$FWLYH6XSHUYLVRU\6LJQDO
+RZWKH&RQWURO3DQHO,QGLFDWHVDQ$FWLYH6X
HUYLVRU
The system goes into Supervisory mode when a monitor module point programmed
with a
SUPERVISORY
,
HAZARD
ALERT
, or
TAMPER
Type Code activates. Figure 13 shows
how the control panel indicates an active supervisory point.
)LJXUH 7KH &RQWURO 3DQHO ZLWK DQ $FWLYH 6XSHUYLVRU\ 3RLQW
When a Supervisory point activates, the control panel does the following:
• Produces a warbling audible tone
• Turns on the Supervisory relay (MPS-6, TB4)
1RWH
,I D ILUH DODUP H[LVWV DQG
WKHUH DUH VLOHQFHG DODUPV WKH
$/$50 6,/(1&('
/(' LV OL
KWHG
D6X
HUYLVRU
DODUP ZLOO UHVRXQG
WKH
DQHO VRXQGHU
• Flashes the
SUPERVISORY
SIGNAL
LED (yellow)
• Displays a Type Code of
TAMPER
(latching)
HAZARD
ALERT
(latching), or
SUPERVISORY
(non-latching) as shown in Figure 16
• Displays
ACTIVE
in the status banner on the control panel, along with information
specific to the device, as shown in Figure 16
)LJXUH 6DPSOH 6XSHUYLVRU\ 6LJQDO 'LVSOD\
• Sends a Supervisory message to the LCD display, History buffer, and installed
printers, terminal mode LCD-80s, and CRT-2s
Continued on the next page...
$&7,9( 7$03(5 ,&8 :(67 :,1*
9,6,7256 /281*( 30 78( 0
)ODVKHV WKH
683(59,625< 6,*1$/
/('
HOORZ
6HQGV D 6X
HUYLVRU
PHVVD
H WR LQVWDOOHG
WHUPLQDO PRGH /&'V
6HQGVD6X
HUYLVRU
PHVVD
H WR LQVWDOOHG
ULQWHUV
6HQGV D 6X
HUYLVRU
PHVVD
H WR LQVWDOOHG &57V
'LV
OD
VD
VX
HUYLVRU
PHVVD
H
RQ WKH /&' GLV
OD
7%
7%
7%
$&7,9( 7$03(5 ,&8 :(67 :,1*
9,6,7256 /281*( 30 78( 0
6WDWXV EDQQHU $&7,9(
7
H &RGH
7$03(5
ODWFKLQ
+$=$5' $/(57
ODWFKLQ
RU
683(59,625<
QRQODWFKLQ
Technical Manuals Online! - http://www.tech-man.com