Audio Amplifiers
9RLFH $ODUP 6
VWHPV
AFC-600 Operations PN 51033:A 3/8/99 67
$$DQG$$$XGLR$P
OLILHUV
Figure 71 shows the AA-100 and AA-120 circuit board and identifies key components:
)LJXUH $$ DQG $$ &LUFXLW %RDUG
7DEOH $$ DQG $$ /('V
Notes:
1. During complete loss of primary (AC) power, the AA-100 or AA-120 operates on
secondary (battery) power. To conserve secondary power, no LEDs light on the
AA-100 or AA-120 while operating on batteries.
2. An audio amplifier does not indicate a trouble condition until 40 seconds after a
fault occurs.
3. To calibrate audio amplifiers, install a 470-ohm resistor at the end of the low-level
audio circuit. If the low-level audio circuit is configured as four-wire looped
circuit, install a 470-ohm resistor at the point furthest from the AMG-1 or ATG-2.
1RUPDO /HYHO /('
UHHQ
,QFRUUHFW /HYHO /('
HOORZ
%DWWHU
7URXEOH /('
HOORZ
%URZQRXW /('
HOORZ
6
HDNHU 7URXEOH /('
HOORZ
,Q
XW 7URXEOH /('
HOORZ
$P
OLILHU 7URXEOH /('
HOORZ
$XGLR *DLQ 5RWDU
6ZLWFK
5HIHU WR +RZ WR
$G
XVW WKH $XGLR *DLQ /HYHO IRU DQ $XGLR
$P
OLILHU RQ
D
H
6:
² %DFNX
WRQH 5HIHU WR +RZ WR 6HOHFW WKH
$$ DQG $$ %DFNX
7RQH RQ
D
H
LED Lights when
NORMAL
LEVEL
The audio amplifier is adjusted properly and operating correctly
during normal (non-alarm) conditions.
INCORRECT
LEVEL
The audio amplifier is out of adjustment during normal (non-alarm)
conditions.
BATTERY
TROUBLE
The battery voltage is below a sufficient level.
BROWNOUT
The AC power source is below a sufficient level. During a complete
loss of AC power, no LEDs will light on the AA-100 or AA-120.
SPEAKER
TROUBLE
An open circuit condition occurs in the four-wire, high-level output.
INPUT
TROUBLE
A loss of the low-level audio input signal, or an amplifier failure
(see notes below).
AMPLIFIER
TROUBLE
A loss of the low-level audio input signal, or an amplifier failure
(see notes below).
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
