NSK MEGATORQUE M-ESB-YSB2020AB300 - BF: Brake Sequence Function; BM: Backspace Mode

— 8-7 —
B
B
3
3
t
t
y
y
p
p
e
e
B
B
5
5
t
t
y
y
p
p
e
e
2
2
3
3
t
t
y
y
p
p
e
e
2
2
5
5
t
t
y
y
p
p
e
e
8. Glossary of Command and Parameter
« BF : Brake Sequence Function
Format : BF
Data : 0 --- Brake sequence function inactive
1 --- Brake sequence function active
Shipping set : 0
Default : 0
l The BF commands selects the brake sequence function.
l The TS or ?BF command reports the current setting.
l Refer to “7.1.10.4. Brake Sequence Function” for details.
！
Caution: A YSB Megatorque Motor equipped with brake, a power source (24
VDC) for brake-off, and wiring for brake are necessary to use the brake
system.
！
Caution: For the B3 and 23 type Driver Units, the BF command is effective only
for TY8 I/O combination type, while it is ineffective for other I/O
combination type. When BF1 is specified, the parameter OM will be
inactive.
« BM: Backspace Mode
Format : BM data
Data : 0 or 1
Shipping set : 1
Default : 0
l The BM command changes the function of the BS
key.
BM0 : A press of the BS
key cancels an entered character string on a line.
BM1 : A press of the BS
key deletes a character.
l The TS or ?BM command reports the current setting.