— 7-64 —
B
B
3
3
t
t
y
y
p
p
e
e
B
B
5
5
t
t
y
y
p
p
e
e
7.3. RS-232C Communication
7.3.3. Communication with Personal Computer
2
2
3
3
t
t
y
y
p
p
e
e
2
2
5
5
t
t
y
y
p
p
e
e
7.3.3. Communication With Personal Computer
l Use NSK MegaTerm application software that is available on the web site of NSK Precision
America, Incorporated (http://www.npa.nsk.com
) for download. Or follow the procedure
described below for communication with a personal computer.
l The following describes how to store the parameters of the ESB Driver Unit using Hyper
Terminal communication software that is provided with “Windows” as a standard feature.
l The user shall provide the communication cable. Pin-out of the D-sub 9pins connector of the
ESB Driver Unit is different from DOS/V machine. Refer to “2.8.1. CN1: RS-232C Serial
Communication Connector” and the manual of the personal computer to be used.
7.3.3.1. Set-up of HyperTerminal
1) Start HyperTerminal.
[ (Start menu) ® (Program) ® (Accessory) ® (HyperTerminal) ]
2) The dialog box of “Setting of connection” is displayed.
Declare the name of connection and set an icon, then press [OK] button.
3) The dialog box of “Telephone-number” is displayed.
Select “Direct to Comx” in “the way of connection N,” then press [OK] button.
(Select Comx in accordance with the user’s environment.)
4) The dialog box of “Property of Com#” is displayed.
Follow the table bellow for input, then press [OK] button.
Table 7-29
Bit/sec.
9 600
Data bit (D)
8
Parity (P)
None
Stop bit (S)
2
Flow control (F)
Hardware
5) Select the menu “File (F)” ® “Property (P).”
Dialog of “Property of xxxx” is shown in the display.
[xxxx is the name of connection declared in the procedure 1).]
6) End of HyperTerminal.
The dialog box stating “Do you store the session xxxx ?” is displayed. Press [Yes (Y)]
button and store the session. Use the session to communicate with ESB Driver Unit
afterwards.
To Next Page
Loading...