5-1
CHAPTER 5 DRAWINGS AND PARTS LISTS
5.1 DRAWINGS AND PARTS LISTS
This section of the manual contains exploded views for the Explorer Balances with associated parts lists.. The exploded
view drawings are designed to identify the parts which can be serviced on the balance in the field. To facilitate this, the
following coding system is used:
When a key number is enclosed by an circle, it indicates that this part is stocked by Ohaus and
can be ordered.
When a key number is enclosed by a four sided box, it indicates that this part is NOT stocked by
Ohaus and cannot be ordered. The parts are shown for clarity only.
NOTE:
In all cases where a part is replaced, the balance must be thoroughly checked after the replacement is made.
The balance MUST meet the parameters of all applicable specifications in this manual.
If further technical information is needed, please contact:
Ohaus Corporation
19A Chapin Road
P.O. Box 2033,
Pine Brook, NJ 07058-2033 USA
Tel: 973-377-9000
Fax: 973-593-0359
In the United States call toll free, 800-526-0659 between 8:00 a.m. and 5:30 p.m. EST.
To Next Page
Loading...
