OHAUS EXPLORER - Appendix A - Explorer EP Loader; A.3 Installing EP Loader Software

APPENDIX A - EXPLORER EP LOADER
A-1
A.1 Requirements for EP Loader
• Pentium 90MHz or higher microprocessor
• VGA 640x480 or higher resolution screen
• Microsoft Windows NT 4.0 or later, or Microsoft Windows 95 or later
• Minimum 24 MB RAM for Windows 95/98, 32 MB for Windows NT
• Minimum 10 MB free space
• CD-ROM
• RS232 cable, Ohaus part number AS017-09 (9 pin) or AS017-02 (25 pin)
• HyperTerminal or another communications program to verify the data.
• If the balance is a Voyager an Explorer display module will be needed.
A.2 Limitations
• The EP Loader software can not be used to restore the personality data in an Explorer
that has the internal calibration option.
A.3 Installing EP Loader Software
1. Insert the EP Loader CD into the CD-ROM.
2. Run the setup executable found on the EP Loader CD to start the installation wizard.
3. Follow the instructions in the installation wizard.
4. If the CD is not available the software can be downloaded at the following
URL. HTTP:// fileshare.ohaus.com/docushare/.
a. Click on Login.
b. Login = ServiceA
Password = aservice
Both are case sensitive
c. Click on the Xerox logo at the upper left.
d. Click on Technical Support.
e. Click on Service Notes.
f. Click on Authorized Service Centers.
g. Click on Explorer Pro Tools.
h. Download all 5 files.