Utilities: Oki LPR Printing Utility • 121
Step1: Install The Utility
1. Insert the 9600 Drivers CD into the CD-ROM drive and wait for
it to autorun.
If the installer does not start automatically, click [Start] →
[Run] and enter E:\Setup (where E is your CD-ROM drive) in
the Open field, then click [OK].
2. Accept the Software License Agreement if you have not
previously accepted it and select [Software Utilities]
3. Click [Install LPR] to begin installation.
4. Verify the [Destination Folder] and [Spool Folder], and click
[Next].
5. Select the startup method you wish to use to launch the utility
when Windows boots:
– To automatically launch the program in an open window,
select [Register in Startup].
– To automatically launch the program minimized as an icon,
select [Launch as minimized]. To open the “Oki LP
UTILITY” window, click the icon.
6. Click [Next].
7. Verify the program folder name and click [Next].
The installation starts.
Important!
• Installation on Windows XP, 2000 and NT4.0 requires
administrator privileges.
• TCP/IP protocol must be installed in your Windows system.
To install the TCP/IP protocol into your Windows system
consult your Windows manual.
To Next Page
Loading...
Need help?
General
