Configuration: Using AdminManager Quick Setup • 16
Configuration:
Using AdminManager Quick
Setup
Introduction
The AdminManager Quick Setup utility allows you to configure the
print server easily and simply without installing any software
packages.
You can configure the following:
• Enable/disable TCP/IP, NetWare, EtherTalk, NetBEUI protocols.
• Set IP address, Subnet Mask and Gateway for TCP/IP manually
or by using DHCP.
• Set NetWare mode and create Queue/Print Server/Printer
objects.
• Zone name and Port name for EtherTalk.
Configuration requires a PC with one of the following Windows
Operating Systems:
• Windows XP
• Windows 2000 Advanced Server/Professional
• Windows Me/98
• Windows NT Server 4.0/Work-station 4.0
IMPORTANT!
• This utility can only be used on a PC that can be connected to
the network with TCP/IP or IPX/SPX.
• This utility must be used on a PC that is located in the same
segment as the printer.
• To create a NetWare queue, NetWare Client 32 or IntranetWare
Client should be installed in your system.
To Next Page
Loading...
Need help?
General
