Printing from UNIX: Configuring the Operating System • 190
To customize output, for example, to add additional commands at
the start of each print job, you can edit a copy of the /usr/spool/lp/
model/rmodel model file then add it using the lpadmin command.
Example
For printer PRINTER_lp, with model file called
PRINTER_model:
# /usr/sbin/lpshut
# /usr/sbin/lpadmin –p
PRINTER_lp –mPRINTER_model
# /usr/sbin/lpsched
AIX 4.1.5 Configuration
The following explanation uses AIX 4.1.5 and an Oki printer as
examples. The absolute path of commands and the method of
configuring may differ with the OS version. Refer to the workstation’s
manual.
If an incorrect IP address is entered, the network may go down or
other damage may occur. Configure after consulting the network
manager.
1. Log in as [root]
If you do not have superuser rights, the network manager
should conduct the configuration.
2. Register the IP address and the host name in the /etc/hosts file.
Example
For IP Address 172.168.29.127 and host name okiprinter
172.168.20.127 PRINTER
To Next Page
Loading...
Need help?
General
