Configuration: Using AdminManager Quick Setup • 17
Using Quick Setup
1. Insert the Network & Utilities CD into the CD-ROM drive and
wait for it to autorun.
If the installer does not start automatically, click [Start] →
[Run] and enter E:\Setup (where E is your CD-ROM drive) in
the Open field, then click [OK].
2. Accept the Software License Agreement if you have not
previously accepted it, then select [Network Card Standard
Setup] and follow the on-screen instructions.
3. When you are done making your selections, review them and if
they are correct, click [Execute].
The new settings are transmitted to the network card, but the
network card is still operating with pre-transmission settings.
4. Click [Finish] to validate the new settings.
The print server reinitializes.
NOTE
The NetWare Client 32 or IntranetWare Client should
be installed on the PC used for the creation of network
queues.
Installation enables the user to create network
queues and perform other functions.
cd.j[g
To Next Page
Loading...
Need help?
General
