Configuration: Configurable Items • 90
Trap
Trap-1
Sets community name assigned to outgoing printer status traps
such as off-line, paper out, etc. Up to 77 alphanumeric characters.
Default is public
.
Trap-2
Enable/disable sending a trap packet for each destination. Five IP
address destinations and one IPX destination can be set up.
NOTE
The default setting is underlined.
AdminManager
[Setup] → [OKI Device Setup] → [SNMP] → [Printer Trap Setup
…] → [Printer Trap Community Name]
Web Browser
[Network] → [SNMP Trap] → [Printer Trap Settings] → {STEP1. Set
Printer Trap Community Name}→ [Printer Trap Community Name]
TELNET
[Setup printer trap] → [Prn-Trap community]
AdminManager
[Setup] → [OKI Device Setup] → [SNMP] → [Printer Trap Setup
…] → [TCP #!–5] → [Detail …] → [Trap Enable]
[Network] → [SNMP Trap] → [STEP3. Set Printer Trap Assignments]
TELNET
[Setup printer trap] → [Setup TCP#1–5 trap] → [TCP#1–5 Trap enable]
To Next Page
Loading...
Need help?
General
