252
USB Setup
Storage Setup
Item Value Description
USB Enable
Disable
Enables/Disables the USB interface.
Speed 480Mbps
12Mbps
Sets the maximum USB interface
transfer speed.
Soft Reset Enable
Disable
Enables/Disables the Soft Reset
command.
Offline Receive Enable
Disable
Enables/disables a function that
maintains the receive-possible state
without changing an interface signal
even though an alarm occurs. When
this is set to Enable, the interface
keeps the receive-possible state even
when you press the Off-line operating
panel switch. The interface sends the
BUSY signal only when the reception
buffer is full or a service call occurs.
This menu is not displayed on a Non-
PS machine.
Serial Number Enable
Disable
Enables/Disables the USB serial
number, used to identify a USB device
to which a PC is connected.
Item Value Description
Check File
System
Off
HDD
Resolves any mismatch between
actual memory and displayed memory
available in a file system and performs
administration data (FAT information)
recovery. Performs these by file
system. This function takes several
tens of seconds to complete.
HDD: Performs recovery only for an
HDD.