247
Settings
Calibration Menu
Item Value Description
Reset settings Execute Resets EEPROM of the CU. Returns a
user’s menu setup to the factory default
state.
Save settings Execute Saves the current menu settings.
Item
Value or
Submenu
Entrty Value Description
Auto density mode ON
OFF
– Sets whether density
adjustment and TRC
compensation is automatically
performed.
ON
: density adjustment is
automatically run under the
printer specified conditions and
reflected in TRC compensation.
OFF
: the printer does not carry
out density adjustment
automatically.
Adjust density Execute – When Execute is selected, the
printer carries out density
compensation immediately and
reflects it in TRC compensation.
Density adjustment must be
carried out when the printer is
idling.
Adjust registration Execute – When Execute is selected, the
printer carries out registration
adjustment automatically.
Registration adjustment must
be carried out when the printer
is idling.
To Next Page
Loading...
Need help?
General
