Troubleshooting: NetBEUI • 214
Troubleshooting:
NetBEUI
The network interface card is not identified.
• Turn the printer off and on again.
• Make sure the network cable is correctly connected.
• Change the cable and try again.
• Make sure that [Microsoft network client] and [NetBEUI] have
been added to the network section of the control panel.
• Make sure the NetBEUI protocol is set to Enable.
• Make sure the factory setting of the workgroup name is
PrintServer and the computer name is ML+ the last six digits of
the MAC address.
• Make sure the computer name of the NIC is different from the
computer name on the network.
Error writing to Prn1.
• Make sure the printer is online.
• If there is an error message indicating the paper has run out, add
more paper and cancel the error.
• Check whether another user is printing. Print after the other user
has finished.
To Next Page
Loading...
Need help?
General
