Oki MICROLINE MX Series User Manual

Chapter 7 Diagnosing Problems
324
DO NOT POWER
OFF
No This is a standard
warning message
that displays while
the printer is
downloading
software.
Do not power off the
printer until downloading
is complete.
DRVR CIR BAD* No Hammer coil count
test failed.
Contact your authorized
service representative.
1
E NET TEST
UNAVAILABLE
Yes The Ethernet
PCBA did not
initialize correctly.
Cycle power. Wait for “E
Net Ready” to display,
then retry operation. If the
fault message appears
again, contact your
authorized service
representative.
1
ERROR: DC
PROGRAM NOT
VALID
Yes The printer cannot
find the data
controller program
or the validation
checksum is
corrupt.
Download the program
again. If the message
appears, replace the flash
memory SIMM.
ERROR: DRAM AT
ADDRESS
XXXXXXXX
No The printer found a
defective memory
location.
Contact your authorized
service representative.
1
ERROR: EC
PROGRAM NOT
VALID
No The printer cannot
find the engine
controller program
or the validation
checksum is
corrupt.
Contact your authorized
service representative.
1
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution

Oki MICROLINE MX Series Specifications

General

Brand	Oki
Model	MICROLINE MX Series
Category	Printer
Language	English