Oki MICROLINE MX Series - Page 323

Fault Messages
323
CLEAR PAPER JAM Yes No paper motion. Clear jam and reload
paper. If this message
recurs, contact your
authorized service
representative.
1
CLEARING
PROGRAM FROM
FLASH
No Status message:
emulation software
successfully
loaded into printer
RAM and the
checksum
matched. The old
program is now
being deleted from
flash memory.
No action is required.
CLOSE PLATEN Yes The platen lever is
open.
Close the platen lever.
COIL HOT No One or more
hammer coils are
overheating.
Contact your authorized
service representative.
1
CTL VOLT FAIL* No Controller voltage
failure.
Contact your authorized
service representative.
1
DIAGNOSTIC
PASSED
No Status message:
the printer passed
its memory and
hardware
initialization tests.
No action is required.
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution