Omron M1 Series User Manual

Function name
1st Drive Control Selection(F42)/2nd Drive Control Selec-
tion(A14)
0: IM V/f control 1: IM Dynamic torque vector control 3: IM V/f control with speed sensor 4: IM Dynamic torque vector control with speed sensor 5: IM Vector control without speed sensor 6: IM Vector control with speed sensor 15: PM Vector control without speed and pole position sensor 16: PM Vector control with speed and pole position sensor
Servo lock N/A N/A N/A N/A N/A
Avail-
able
N/A
Avail-
able
Deceleration characteristics (heavy
brake)
Avail-
able
Avail-
able
Avail-
able
Avail-
able
N/A
Avail-
able
N/A N/A
Pre-excitation N/A N/A N/A N/A
Avail-
able
Avail-
able
N/A N/A
Overload stop (contact stop)
Avail-
able
Avail-
able
Avail-
able
Avail-
able
N/A N/A N/A N/A
Second control switch
Avail-
able
Avail-
able
Avail-
able
Avail-
able
Avail-
able
Avail-
able
N/A N/A
Brake control
Avail-
able
Avail-
able
Avail-
able
Avail-
able
Avail-
able
Avail-
able
N/A
Avail-
able
Carrier Frequency Setting and Derating of Rated Output Current
Derating of the rated output current of the inverter may be required when a high carrier frequency is
set, depending on the heavy/light load mode selection and operating temperature.
Use the inverter in an appropriate environment according to A-1 Derating Table on page A-2.
1 Overview
1-25
M1 Series Standard Type User's Manual (I669)
1-4 Restrictions
1

Omron M1 Series Specifications

General

Input Voltage	200-240V AC
Output Voltage	3-phase 200 to 240 VAC
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Communication	RS-485, Modbus RTU
Enclosure	IP20
Cooling Method	Fan Cooled
Operating Temperature	-10°C to +50°C
Humidity	5-95% (non-condensing)
Altitude	Up to 1000m
Frequency Range	0.5-400 Hz
Storage Temperature	-20°C to +65°C