Omron NJ Series User Manual

6 Programming
6-48
NJ-series CPU Unit Software User’s Manual (W501)
Additional Information
For a function or function block for which the parameter specifies an enumerator, you can also
use the Enumeration#Enumerator notation. Therefore, for the above BinToBCDs_WORD instruc-
tion, the following notation can be used to pass the parameter to Format: _eBCD_FORMAT#
_BCD1.
 Value Checks
When a value is written to an enumerated variable through execution of an instruction, an error will
not occur even if that value is not defined as one of the enumerators of that variable. Therefore, if it
is necessary to confirm that a value is defined as an enumerator of an enumeration, write the user
program to check the value.

Omron NJ Series Specifications

General

Program Capacity	Up to 128 MB
SD Card Slot	Yes
Power Supply Voltage	24 VDC
Motion Control	Yes
USB Ports	1
Operating Temperature	0°C to 55°C
Communication Interfaces	Ethernet/IP, EtherCAT, USB
Safety Function	Optional
Storage Temperature	-20°C to 75°C
Communication Ports	USB
Dimensions	Varies by model
Weight	Varies by model